#3001 Wood Pro-Tect is a water based silicon /
polymer blend that penetrates a seals many types and wood products.
#3001 Wood Pro-Tect treated substrates
substantially. Average water-repellent properties are stable for 24 months.
-
(Exposure
#3001 is primarily used in a situation in which moisture and water
damage need to be prevented because of structural stability concerns and
integrity.) SEALMARK #3001 will increase the susceptible weather ability and
exposure time of moisture to.
COVERAGE
(Wood
Pro-Tect) is used to protect wood and wood products from water and moisture
damage related to environmental.
The
coverage rates for #3001 WoodPro-Tect will vary
slightly depending on the substrates being applied to. Average coverage rate
for #3001 will be between 200-300sq.ft.
PROPERTIES
DRYING TIME
The
drying time of #3001 is dependent upon the ambient air temperature and
relative humidity. Under normal conditions (70'f/55% R.H.) the time elapsed for
acceptable curing time is 8hrs. After 24hrs. period the #3001 is a completely cured form.
APPLICATION
PROCEDURES
Job Condition – Air and surface temperature for application
of #3001
(Wood
Pro-Tect) must be at least 40 degrees (f), and must remain so for a period of
at least 24 hrs.
Protection – Temporary protection shall be provided at
all times for specified duration until (#3001) has achieved a completely cured
state to protect form all weather, natural elements and other potential damage.
Substrate Preparation – Surface must be clean, dry, structurally
stable and surface temperature must be 39'(f). Surface areas must be free
of grease oils, and solvents that can possibly interfere with the bond
integrity of SEALMARK #3001.
Mixing Product – Proper mixing procedure for SEALMARK
#3001 is to stir vigorously for approximately 35-45 seconds. A drill and a
standard paint-mixing bit are recommended. Be careful as to not whip air into
the coating.
Application – SEALMARK #3001 can be applied a paintbrush, paint roller or low-pressure spray
equipment. Apply SEALMARK #3001 in a uniform consistent manner as to
completely cover and penetrate the approved substrate. When applying, take note
to completely cover and fill gaps, crevlees and surface voids to ensure
complete penetration into the substrate. On rough surfaces a roller is
recommended. Apply #3001 in a wet manor.
ONCE SEALMARK #3001 HAS DRIED ITCAN NOT BE RECOATED WITH #3001 OR
ANY OTHER PRODUCT.
It is
recommended that a small test be performed in an inconspicuous area by applying
#3001 and observing that the surface appearance will be acceptable.
Clean up – Use soap and water for clean up when
product is not dry. System materials are water-soluble and non-toxic. Clean up
any spills, over spray, or residue of the system materials before they have time
to set. Cured or dried system materials are not water-soluble an may prove to be difficult to remove without damage to the
substrate or other materials which it has dried on. Dispose of waste materials
and empty containers into an approved waste disposal facility. Never dump
materials into storm or sanitary sewers, nor into
bodied of water.
STORAGE
SEALMARK
#3001 must be
stored at a minimum temperature of 40'(f).
DO NOT ALLOW PRODUCT TO FREEZE!
Storing
in temperature closet to room temperature 70'(f) will result in easier
application. Always store in tightly sealed containers and out of direct
sunlight. Shelf life of SEALMARK #3001 in sealed containers is one year
from date manufacture.
Sealmark
Corporation,
Distributed by